Broadhead tuning

[ontarget7]

Just cut those down to 26-27" raw shaft. This will probably put you close to 10.5%-11%. I am a 29" draw and my arrows generally run 27" raw shaft. I would take off the wraps as well.

 

[elkgrunt]

I've been looking for more information on tuning the binary cam system in my insanity cpx, and everything I have seen so far says to set the rest for center shot, then if my arrow isn't flying right to give one side of the cable and extra twist on top and bottom. Has anyone had any experience with this? I used to shoot a mathews with the solo cam, so the binary cam system is new to me

Anytime you twist a cable on your bow,you will affect timing.

 

[tdcour]

Keep me posted on your progress

Well, got everything tuned last night and sighted in to 50. Too windy this weekend to get the rest of my pins set up, but I'm shooting bullet holes now! Adjusted my rest to center shot and up a little, then worked on the cables. Made sure everything was still in time and and a little tweak to my form and everything was perfect. I haven't checked my broadhead flight, but I'm betting its going to be bettter. Thanks for the help!

 

[ontarget7]

Well, got everything tuned last night and sighted in to 50. Too windy this weekend to get the rest of my pins set up, but I'm shooting bullet holes now! Adjusted my rest to center shot and up a little, then worked on the cables. Made sure everything was still in time and and a little tweak to my form and everything was perfect. I haven't checked my broadhead flight, but I'm betting its going to be bettter. Thanks for the help!

Nice to see your getting it worked out bro. Keep up the good work

Not a problem anytime
Shane