Results 1 to 3 of 3
  1. #1
    Senior Member
    Join Date
    Nov 2012
    Location
    Iowa
    Posts
    102
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Congratulations
    0
    Congratulated 0 Times in 0 Posts

    Removing epoxy from metal.

    Wondering if anybody knows how to remove an epoxy from a parkerized metal finish?

    Removed a Lyman 48 sight from a 1903 springfield last night and it appears to have an epoxy based 'pad' underneath.

    Would like to remove the epoxy and fill the holes with plug screws.

  2. #2
    Senior Member
    Join Date
    Jun 2011
    Location
    Dolores, Colorado
    Posts
    4,637
    Thanks
    1,121
    Thanked 1,633 Times in 967 Posts
    Congratulations
    203
    Congratulated 297 Times in 75 Posts
    I would probably not use any of the chemical based removers, as they probably would attack the blueing on the metal too. You might try an auto body shop that specializes in Corvettes. They use a baking soda based blast that will take paint off but not hurt the fiberglass. Worth a try.
    Colorado Cowboy
    Cowboy Action Shooter; Endowment Life Member-NRA, NRA certified Range Safety Officer, Pistol Instructor, Rifle Instructor, RMEF, Boone & Crockett Club.
    The Original Rocket Scientist-Retired
    "My Father always considered a walk in the mountains as the equivalent of church going."
    Aldous Huxley

  3. #3
    Senior Member
    Join Date
    Jun 2011
    Location
    Peoples Republik of Kalifornia
    Posts
    616
    Thanks
    51
    Thanked 117 Times in 96 Posts
    Congratulations
    46
    Congratulated 31 Times in 6 Posts
    I would try heating it a little bit with a small torch. You also might be able to freeze it, and knock it off with a plastic straight edge. Neither of these should hurt the Parkerizing, as it is pretty tough. You may have to refresh the threads in the holes after removing the pad to get the epoxy out of them.
    Patron Life Member, NRA; Life Member RMEF, SCI, NAHHC, NSRPA; Member CRPA

 

 

Similar Threads

  1. Sheet metal worker
    By tinman in forum New Members Introduction
    Replies: 12
    Last Post: 02-20-2014, 03:22 PM
  2. Removing old velvet?
    By sjsmallfield in forum Back at the Tailgate
    Replies: 0
    Last Post: 01-25-2013, 07:07 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •