Results 1 to 3 of 3

Thread: 7 mag/RL22

  1. #1
    Member
    Join Date
    Nov 2014
    Location
    Kentucky
    Posts
    71
    Thanks
    21
    Thanked 5 Times in 4 Posts
    Congratulations
    13
    Congratulated 8 Times in 3 Posts

    7 mag/RL22

    Any of you guys using RL22 for 7mm Rem mag? Specifically with Nosler bullets? I had previously been using IMR4350 and 150gr Nosler Partitions but I am out of powder and IMR4350 is becoming hard to find.

  2. #2
    Senior Member
    Join Date
    Dec 2015
    Location
    Indiana
    Posts
    230
    Thanks
    321
    Thanked 79 Times in 52 Posts
    Congratulations
    760
    Congratulated 63 Times in 13 Posts
    I tried rl22, but didn't have much luck. 4350 was the best I tried, and I too had some trouble finding it. I'd say keep looking and buy a bunch when you find it.

  3. #3
    Senior Member
    Join Date
    Mar 2016
    Location
    Gypsum, Co
    Posts
    1,954
    Thanks
    120
    Thanked 758 Times in 540 Posts
    Congratulations
    27
    Congratulated 157 Times in 38 Posts

    I just got done working up a load for my brother in law for his 7mm Rem mag. I used RL19, RL22, and some IMR 4831. I used Nosler and Barnes bullets and finally settled for a Barnes 140 grain TTSX over 67 grains of RL19. The same load using RL22 was 100 fps faster but the RL19 was more accurate. I tried some Nosler 160grain Accurbonds but couldn't get them to shoot very well.

    From what I have read RL22 is little bit more temperature sensitive than RL19 but I make up my loads in the summer and shoot them in the cooler months so I don't worry about that. RL22 has worked quite well for me in my .340 Weatherby and if you work up your load for your 7mm it should also work for that.
    If you don't care where you are, you are not lost....

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •